Full 1.8-30MHz Operation
Custom designed inductor switch, 1000 volt tuning capacitors, Teflon insulation washers and proper L/C ratio gives you arc-free no worries operation with up to 300 Watts 1.8 to 30 MHz.

Tunes any Antenna
Tunes out SWR on dipoles, verticals, inverted vees, random wires, beams, mobile whips, shortwave receiving antennas.... Nearly anything! Use coax, random wire or balanced lines. Has heavy duty 4:1 balun.

Custom Inductor Switch
The inductor switch is the most likely component to burn up in any antenna tuner. MFJ's inductor switch in the MFJ-949E was custom designed to withstand the extremely high RF voltages and currents that are devloped in your tuner.

8 Position Super Antenna Switch
Lets you select two coax fed antennas, random wire/balanced line or built-in dummy load through your MFJ-949E or direct to your transceiver.

More hams use MFJ_949s than any other antenna tuner in the world!
Has MFJ's full size 3 inch lighted Cross Needle Meter (not a puny "meter" you can't read). Lets you easily read SWR, true peak forward and average reflected power simultaneously on 300 Watt or 30 Watt ranges. Lamp has on/off switch, requires 12 VDC or 110 VAC with MFJ-1312D.

QRM-Free PreTune
MFJ's QRM-Free PreTune lets you pre-tune your MFJ-949E off-the-air into it's built-in dummy load! Makes tuning your actual antenna faster and easier.

Plus much more!
Full size built-in non-inductive 50 Ohm dummy load, scratch-proof Lexan multi-colored front panel, superior cabinet and construction and more!