 | Built in rig control, RS232 to TTL interface
tested with Icom and Yaesu; electrically
compatible with Ten Tec and Kenwood. |
| Rig control is possible along with sound card
PTT control and CW keying on a SINGLE serial
port using Hamscope or MixW software.
|
| Single serial port pass through for radios
directly RS232 controlled (newer Yaesu and
Kenwood).
|
| Rig control, FSK keying and sound operation is
supported using two serial ports or when using
two separate programs.
|
| Your microphone may be bridged to computer as
well as radio for on-the-fly digital recording.
|
| Transmit speech processing is done by looping
mic. audio through the sound card using
appropriate EQ and compression software.
|
| Plug in 2nd mic. jack allows instant automatic
switch over to a headset mic. without unplugging
your main mic.
|
| Both 1/4" and 1/8" front panel
headphone jacks to monitor computer receive and
transmit audio; no searching for adaptors.
|
| Computer speaker PTT activated
mute-on-transmit works with speech processing
and for general sound card operation.
|
| Four ways to connect the receive audio from
your radio: direct, mic jack, line out, speaker
out. A radio speaker loop jack is included.
|
| Fully automatic operation; your mic. always
works, your computer always works, no manual
switching, no plugging or unplugging, ever.
|
| No extra manual selector switches needed,
three DPDT relays for true automatic operation,
unlike other sound card interfaces.
|
| Simpler operation than other brands, you never
have to remember to push un-needed switches when
operating.
|
| PTT override feature; your mic. can always
override the computer, perfect for contesting or
SSTV operation.
|
| PTT interrupt feature can stop a computer
program, our innovation, specially designed for
DVK and transmit speech processing.
|
| Complete with 8pin screw on and RJ45 radio mic.
cable compatibility. 4pin screw on adaptor kit
as an option.
|
| Automatic switching between your mic. and the
computer; never a hot mic.
|
| You may always a RIGblaster Pro connected,
everything always works, no bypass switches
required. Only your mic. works with switches
off.
|
| On/Off switch. You mic. works normally with
other functions disabled. Other RIGblaster use
less than 0.1 watts and do not need an on/off
switch.
|
| Fully isolated CW keying output for direct
keying of your rig's CW. This jack is for use
with non-sound card software using serial DTR
control.
|
| Fully isolated FSK keying output for direct
keying of your rig's FSK jack. This jack is for
use with non-sound card software using serial
TXD control.
|
| Front panel LED indicators show whether
computer audio or mic. audio is routed to the
radio.
|
| Front panel LED indicator shows if the
computer audio is present at an adequate level
for transmit or receive.
|
| Front panel LED indicators show PTT, CW and
FSK activation status making it easy to check
the operation of your software.
|
| Front panel audio drive control allows setting
the transmit audio from the computer to your
radio without fumbling with your mouse.
|
| Dual rear panel RCA PTT jacks provide for a
foot switch, amplifier and sequencer
connections. This supports our PPT override and
interrupt features.
|
| Total ground loop isolation using 3 shielded
isolation transformers, 3 optoisolators, 3
relays and an isolating DC to DC converter.
|
| Power supply included, no charge. Your choice
of 120 VAC or 230 VAC
|
| 12 VDC operation easily done without the
included power supply. See our support page for
the proper hookup. |
